MENUPRICE REDUCTIONS
- Computer Network Accessories
-
- » CABLE TESTERS#09346
Cable tester RJ-45, RJ-11 witch port flash function WT20A
A simple diode tester which enables checking the correctness of the plugs in computer and telephone connections.
Port flash function.Tested cabling RJ45,
RJ 11Detected failures incorrect connections,
short circuits and interruptions in the wiring,
port flashAdditional features PoE voltage test,
RJ45 and RJ11 crimping quality testPower 9V 6F22 battery Packaging Blister Batteries not included.
#03059Cable tracker and cable tester, VFL WT22C
The cable tracker is made for identifying and searching cables without breaching their insulation.
Additionaly, the device enables displaying the network cable connection map. The WT22C tester is equipped with a laser source of visible light, which also enables diagnostics of optical networks.Cables tested RJ45,
RJ11,
2.5mm ferrule fiberOperational modes normal and slow Performed tests connection map,
telephone line voltage indicator,
polarization index,
continuity testSignal dual alternating tone Output signal level 15V p-p Battery type 6F22 9V (reciever),
3x 1.5V AA (toner)The set includes a transmitting and receiving module, a RJ45 patchcord, a test lead finished with crocodile clips and earphones.
#03057Digital cable tracker and cable tester WT22D
The cable tracker is made for identifying and searching cables without breaching their insulation.
Thanks to the use of a digital signal, the sound heard in the receiver is free from any kind of interference that occurs when using analog finders.
Additionaly, the device enables displaying the network cable connection map.Cables tested RJ45,
RJ11Operational mode normal and slow Performed tests connection map,
telephone line voltage indicator,
polarization index,
continuity testSignal dual alternating tone or digital Output signal level 23V p-p Battery type 6F22 9V (reciever),
3x 1.5V AA (toner)The set includes a transmitting and receiving module, a RJ45 patchcord and a test lead finished with crocodile clips.
#03058Digital cable tracker and cable tester WT22E
The cable tracker is made for identifying and searching cables without breaching their insulation.
Thanks to the use of a digital signal, the sound heard in the receiver is free from any kind of interference that occurs when using analog finders.
Additionaly, the device enables displaying the network cable connection map.Cables tested RJ45,
RJ11Operational mode normal and slow Performed tests connection map,
telephone line voltage indicator,
polarization index,
continuity testSignal dual alternating tone or digital Output signal level 23V p-p Battery type 6F22 9V (reciever),
3x 1.5V AA (toner)The set includes a transmitting and receiving module, a RJ45 patchcord and a test lead finished with crocodile clips.
#03056Digital cable tracker and cable tester WT25D
The cable tracker is made for identifying and searching cables without breaching their insulation.
Thanks to the use of a digital signal, the sound heard in the receiver is free from any kind of interference that occurs when using analog finders.
Additionaly, the device enables displaying the network cable connection map.Cables tested RJ45,
RJ11Operational mode normal and slow Performed tests connection map,
telephone line voltage indicator,
polarization index,
continuity testSignal dual alternating tone or digital Output signal level 23V p-p Battery type 2x 6F22 9V The set includes a transmitting and receiving module, soft case, a RJ45 patchcord and a test lead finished with crocodile clips.
- » DIGITAL MULTIMETERS WITH LAN TESTERS
- No Calibration is needed for general measurement
- Allow User Calibration for precise measurement
- Able to measure cable made of different material
- Only need to connect the cable at one side
- Measure up to 600 meters
- Able to measure LAN cable (both 4P4C & 8P8C), Phone wire and BNC cable
- Intelligent wiremap (Shorts and Split Pairs)
- Port Blink Test
- PoE voltage measurement
- Digital and Analogue signal selectable
- Auto power off
- With display backlight and flashlight
- Sensitivity adjustable
- With Built-in Multimeter Functions
#03030Cable tester RJ-45, w/LCD, digital wire tracker, digital multimeter (WT36C)
Features:
- » ADVANCED CABLE TESTERS#03807
Cable tester RJ-45, w/LCD and scan detector (NOYAFA NF-300)
The NF-300 tester can detect disturbances and errors occurring in the network of coaxial, telephone, UTP and FTP cabling, categories 5, 5E, 6, 7.
The tester can measure the length of the cable, which also allows finding the exact location of its damage. The possibility of calibration increases the accuracy of the measurement.
The set is equipped with a finder that allows tonal location of pairs of wires.The batteries are not included.
#03060Cable tester RJ-45, w/LCD, digital wire tracker, WT26C
The WT26C digital wire tracker is an advanced device used for complex network cabling tests. It enables basic network cabling diagnostics- connection map, measurement of length and distance to fault.
Additionally, it is equipped with a digital and analog signal generator, enabling tracing the cable route and identifying pairs.
The device is equipped with a clear, backlit LCD display.Tested cabling RJ45,
RJ11,
BNCFunctionality location of the damage site,
cable length measurement,
short circuit detection,
interruptions,
reverse connections,
measurement of the distance to damage,
temperature compensation,
sound signalingWiring tests cable lenght,
connection map,
digital pair finder with generatorCable length measurement 300 m Measurement of the distance to damage yes Ergonomics big and clear LCD display,
automatic shutdown,
long operating timePower 1800mAh battery,
rechargable by micro USBDimensions 173x87x37 mm (main),
187x35x29 mm (reciever)The kit includes:
- main unit,
- wire pair finder
- USB A (M) - micro USB (M) connector
- crocodile clips
- RJ45-RJ45 connector
#03090Cable tester RJ-45, w/LCD, digital wire tracker, WT26G
The WT26G digital wire tracker is an advanced device used for complex network cabling tests. It enables basic network cabling diagnostics- connection map, measurement of length and distance to fault. It also enables simple PoE tests - polarity, voltage measurement.
Additionally, it is equipped with a digital and analog signal generator, enabling tracing the cable route and identifying pairs.
The device is equipped with a clear, backlit LCD display.Tested cabling RJ45,
RJ11,
BNCFunctionality location of the damage site,
cable length measurement,
short circuit detection,
interruptions,
reverse connections,
measurement of the distance to damage,
temperature compensation,
sound signaling,
PoE testsWiring tests cable lenght,
connection map,
digital pair finder with generator,
port blink testCable length measurement 400 m Measurement of the distance to damage yes Ergonomics big and clear LCD display,
automatic shutdown,
long operating timePower 1360mAh battery rechargable by micro USB (transmitter),
9V 6F22 (reciever)Dimensions 173x87x37 mm (main),
187x35x29 mm (reciever)The kit includes:
- main unit,
- wire pair finder
- USB A (M) - micro USB (M) connector
- crocodile clips
- RJ45-RJ45 connector
-
- Communication for industry
-
- » PoE SWITCHES SMART OR MANAGED#07674
Unmanaged industrial switch, 4x 100/1000 RJ-45 PoE, 1x 100/1000 RJ-45, 1x 1000 SFP (Wave Industrial WO-IS-M2GF4GT-4POE-M)
Physical Ports 100/1000 Base-T(X) Ports in RJ45 Auto MDI/MDIX 4 w/PoE 1000Base-FX SFP ports 2 Technology Ethernet Standards IEEE 802.3u for 100Base-TX and 100Base-FX,
IEEE 802.3ab for 1000Base-T,
IEEE 802.3z for 1000Base-XLED Indicators power,
RJ45 ports (5)Power Dual DC inputs. 48÷57VDC on 4-pin terminal block Power consumption (typical) 6.5W Physical Characteristic Enclosure IP-40 Dimension (W x H x D) 33mm x 115mm x 85mm Weight 350g Environmental Storage Temperature -40÷85°C Operating Temperature -40÷85°C Operating Humidity 5%÷95% Non-condensing Regulatory approvals EMI FCC Part 15,
CISPR (EN55022) class A,
EN50155 (EN50121-3-2,
EN55011,
EN50121-4)EMS EN61000-4-2 (ESD),
EN61000-4-3 (RS),
EN61000-4-4 (EFT),
EN61000-4-5 (Surge),
EN61000-4-6 (CS),
EN61000-4-8,
EN61000-4-11Shock IEC60068-2-27 Free Fall IEC60068-2-32 Vibration IEC60068-2-6 Safety EN60950-1 Warranty Warranty period 5 years
-
Page 12 of 22
|
