Atel Electronics
[-]remove#04471 [-]remove#06892 [-]remove#08447 [-]remove#07988
Patch cable S/FTP (PiMF) cat. 6A, 0.25 m, yellow Media converter 1x RS232 (DB9) + 1x RS-422/485 (TB, 3kV isolated) (ORing ISC-1112-I) Industrial Gigabit High Power Injector, 2x10/1000 RJ-45 PoE + 2x10/1000 RJ-45 (ORing INJ-102GT-24V) Unmanaged switch, 8x 10/100 RJ-45 PoE, slim housing (ORing IPS-1080A)
Cable
Shielding type / cat S/FTP cat 6A - - -
Cable construction 4x2x7/0.15Cu + foil AL + oplot + LSOH - - -
Core diameter / AWG 26 - - -
Outer diameter 4,1 mm,
LSOH
- - -
Connector
RJ45 plug / molded 8p8c shielded,
gold plated pins
- - -
Impedance 100 Mhz 100 +/- 5 Ohm - - -
Frequency 500 MHz - - -
Working temperature 0°C - 60°C - - -
RoHS 2011/65/EU EN IEC 63000 - - -
Standards EN 50173-1,
ISO/IEC 11801,
IEC60332-1,
IEC-60603-7-5,
TIA/EIA 568B
- - -
Environmental
Storage Temperature - -25÷85°C -40÷80°C(-40÷176°F) -40÷85°C
Operating Temperature - -10÷70°C -20÷70°C (-4÷158°F) -40÷70°C
Operating Humidity - 5%÷95% Non-condensing 5%÷90% Non-condensing 5%÷95% Non-condensing
Fault contact
Relay - - - Relay output to carry capacity of 1A at 24VDC
LED Indicators
PoE Indicators - - 2 x LED,
Blue On - PoE Device Link,
Blue Blinking - Detecting PoE Device,
Blue Off - None PoE Device Detected
-
Fault indicator - - - Amber - Indicate PWR1 or PWR2 failure
10/100TX RJ45 port Indicator - - - Green for port Link/Act.,
Green for PoE power injected
Power Indicator - Green x1 PWR / Ready 1 x LED,
Green On - Power is on and functioning Normally
Green - Power LED x 2
TxD Indicator - Green x1 - -
RxD Indicator - Green x1 - -
Operating Voltage
Input Voltage - - 24 ~ 57 VDC / 4-pin terminal block -
Output Power - - 50V / 600mA,
30 Watts max. Per port
-
Physical Characteristic
Enclosure - ABS IP-30 IP-30
Dimension (W x D x H) - 71.2mm x 25.3mm x 100.6mm 41mm x 70mm x 95mm 26.1mm x 94.9m x 144.3mm
Weight - 130g 370g 412g
Physical Ports
10/100 Base-T(X) Ports in RJ45 Auto MDI/MDIX - - - 8
RS-232 Connector - DB9 (Female) - -
10/100/1000Base-T(X) in RJ-45 Ethernet Port Input - - 2 -
RS-422/485 Connector - 10-pin terminal block opto-isolated to 3kV - -
10/100/1000Base-T(X) in RJ-45 Ethernet Port with P.S.E. Output - - 2 -
RS-232 Signals - TxD,
RxD,
GND
- -
RS-422/485 Signals (RS422) - TxD+,
TxD-,
RxD+,
RxD-
- -
RS-422/485 Signals (RS485) - Data+,
Data-,
GND
- -
Baud Rate - 300bps to 115.2Kbps - -
Data bit - 5, 6, 7, 8 - -
Stop bit - 1, 1.5, 2 - -
Parity - None,
Even,
Odd,
Space,
Mark
- -
Flow Control - XON/XOFF (software),
Auto Hardware Direction Control for RS-485
- -
Power
Overload current protection - - - present
Reverse polarity protection - - - not present
Input power - 10÷30VDC on 10-pin terminal block - Dual DC inputs. 50VDC on 6-pin terminal block
Power consumption (typical) - 2.2W - 4.5W
Protection
Short Circuit Protection - - present -
Over Load Protection - - present -
High Voltage Protection - - present -
Regulatory approvals
EMI - FCC Part 15,
CISPR (EN55022) class A
FCC Part 15,
CISPR (EN55022) class A
FCC Part 15,
CISPR (EN55022) class A
EMS - EN61000-4-2 (ESD),
EN61000-4-3 (RS),
EN61000-4-4 (EFT),
EN61000-4-5 (Surge),
EN61000-4-6 (CS),
EN61000-4-8,
EN61000-4-11
EN61000-4-2 (ESD),
EN61000-4-3 (RS),
EN61000-4-4 (EFT),
EN61000-4-5 (Surge),
EN61000-4-6 (CS),
EN61000-4-8,
EN61000-4-11
EN61000-4-2 (ESD),
EN61000-4-3 (RS),
EN61000-4-4 (EFT),
EN61000-4-5 (Surge),
EN61000-4-6 (CS),
EN61000-4-8,
EN61000-4-11
Shock - IEC60068-2-27 IEC60068-2-27 IEC60068-2-27
Free Fall - IEC60068-2-32 IEC60068-2-32 IEC60068-2-32
Vibration - IEC60068-2-6 IEC60068-2-6 IEC60068-2-6
Safety - EN60950 EN60950-1 EN60950-1
Technology
Ethernet Standards - - - IEEE 802.3 for 10BaseT,
IEEE 802.3u for 100BaseT(X),
IEEE 802.3x for Flow control,
802.3at PoE specyfication
MAC Table - - - 2048 MAC addresses
Processing - - - Store-and-Forward
Warranty
Warranty period - 2 years 2 years 5 years
Net Price 0.806 USD 119.00 USD 212.00 USD 327.00 USD

« return to products list